Technical Data:


    Composition/type: methacrylate monomers
    Appearance/Color: translucent, amber liquid
    Viscosity @25ºC : 5-10 cP
    Specific Gravity: 1.03
    Flash Point: >200ºF
    Vapor Pressure: Florescence Yes


    Appearance: hard, translucent,plastic Hardness Shore D (ASTM D2240): 75-85


    Cactus Juice is heat cured at temperatures between 80ºC -96ºC, (177º F -205º F ). Cactus Juice cures when the temperature of the resin within the blank reaches 90º C for a minimum of three minutes. The typical small shop method for curing is in a counter top toaster oven until internal blank temperature reaches the cure temperature for five minutes or more. This usually take 1-1.5 hours for a typical small batch of 10 pen blanks. Blanks with large cross section areas or larger batches of blanks may require longer processing times to achieve the required cure temperature.


    Cactus Juice is formulated from the highest quality monomers to maximize the service operating range of the polymer. Cactus Juice is recommended for continuous service from –54ºC, (-65ºF) to 189ºC, (372ºF).


    Cactus Juice is easy to store and will exhibit an approximately 6 month shelf life under proper storage conditions. The resin should be stored in its original container and away from direct sunlight or other sources of UV light. Storage temperatures should be maintained below 27ºC (80ºF). Storage in a refrigerator is recommended.



    Cactus Juice resin can be safely handled using normally accepted practices for handling non-toxic industrial chemicals. Rubber gloves should be worn when handling liquid Cactus Juice. Avoid excessive skin contact and wash thoroughly with water and mild soap if contact occurs. If dermatitis occurs, seek medical attention and avoid further exposure. Avoid accidental contact with the eyes by using safety glasses. If accidental contact with the eyes should occur, flush immediately with copious amounts of clean water and obtain medical attention.


    Cured Cactus Juice is inert and can be disposed of as ordinary industrial trash. Uncured resin should be cured before disposal. Resin in solution in wash water effluent is biodegradable.


    Information presented herein has been compiled from sources considered to be accurate and reliable, but is not guaranteed to be so. Nothing herein shall be considered as recommending practices or products in violation of any patent, law or regulation. It is the user's responsibility to determine the suitability of any material for a specific purpose and to adopt such safety precautions as may be necessary. CONESTOGA WORKS MAKES NO WARRANTIES REGARDING THE PRODUCTS AND DISCLAIM ALL EXPRESS OR IMPLIED WARRANTIES, INCLUDING ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

    Thank you for your business!